INSTRUCTIONS

ATTACHING THE SeedHoop TO HANGING FEEDERS:

  1.Lay the SeedHoop on the ground or other flat surface.

2.Place your bird feeder in the center of the SeedHoop.

3.Attach the snap hooks to the D rings on the SeedHoop.

4.Adjust each cord by squeezing the button and pulling the cord through to the desired length.

5.Hook the metal hooks over the rim of your bird feeder, distributing them as evenly as possible.

Note: The optimum distance the SeedHoop should hang below your feeder is about 6” -- If it exceeds 6”, more seed will be lost; less than 6”, birds will not be able to feed as easily under the feeder.

ATTACHING THE SeedHoop TO POLE BIRD FEEDERS:

  1.Remove your bird feeder from the pole.

2.In the center of the SeedHoop, cut a small X (just smaller than the diameter of the pole).

3.Gently push the SeedHoop over the top of the pole (if needed, enlarge the X just enough to allow the SeedHoop to fit snugly over the pole).

4.Reposition the bird feeder on the pole.

5.Attach the snap hooks to the D rings on the SeedHoop.

6.Adjust each cord by squeezing the button and pulling the cord through to the desired length.

7.Hook the metal hooks over the rim of your bird feeder, distributing them as evenly as possible.